How To Clean; The Belt - Hoover Encore Supreme 53391 Owner's Manual

How to clean

Disconnect cleaner from eiectri-
cai outlet.
The secondary filter is located
inside the cleaner behind the paper
bag. To remove filter, first remove
cover of cleaner, then lift out filter.
Clean filter by rinsing it in water.
When dry, slide filter back into
position.
Do not operate cleaner without
the secondary fiiter in place.

The belt

The belt in your power nozzle drives the agitator. It has been designed
specifically for use in this cleaner and is important for effective operation.
What to buy
There are other belts manufactured that are similar in shape and size, but
may not be designed for the HOOVER power nozzle. Such belts may not
operate the agitator correctly and may create stress which could damage
your power nozzle. Use only a genuine HOOVER belt No. 38528-011 when
a belt replacement is necessary.
When to replace
The belt, located under the nozzle cover, should be checked from time to
time to be sure it is in good condition. To check, remove the nozzle cover
(see following section). Replace the belt if it is stretched, cut, or broken.
How to replace
Disconnect cleaner from eiectri-
cai outlet and disconnect power
nozzle from cleaner.
Turn nozzle over and unscrew the
4 recessed Phillips head screws.
Note: Do not remove the 3
the triangle formation
screws in
these hold the motor in place.
as
13
1