Table of Contents
Advertisement
General operation
Operate carpet cleaning machine only at voltage specified
on data plate on back of cleaner.
ON/OFF pedal
Plug carpet cleaning machine into a properly grounded
outlet.
Step on pedal to turn carpet cleaning machine on. Step on
pedal again to turn carpet cleaning machine off.
Handle release pedal
Step on pedal to lower handle to operating position. Handle
does not lock into a single position but "floats" to allow conve-
nient operation.
Automatic "shut-off"
When the recovery tank (lower tank) is full, the automatic "shut-
off"mechanism will shut off the carpet cleaning machine suction.
When this happens, the red float disk will rise to the top of the
recovery tank lid (see illustration). The carpet cleaning machine
will no longer pick up dirty solution and the motor sound will
become noticeably higher in pitch.
When this happens, turn carpet cleaning machine off and
empty recovery tank before continuing use.
NOTE: Check the recovery tank often. Empty tank when it
appears full even if the automatic shut-off has not engaged.
Check clean solution tank also; it may need to be refilled.
ON/OFF
PEDAL
HANDLE
RELEASE
PEDAL
FLOAT DISK
To transport
Turn carpet cleaning machine off before transporting.
To move your carpet cleaning machine from room to room, put
handle in upright and locked position, tilt carpet cleaning
machine back on wheels, and push forward.
The carpet cleaning machine may also be lifted by placing a
hand under the upper clean solution tank handle as shown.
The tanks
Clean solution tank (upper tank)
The clean solution tank holds the cleaning solution that is to be
dispersed onto the surface to be cleaned.
How to fill
Disconnect carpet cleaning machine from electrical outlet.
TANK
HANDLE
Place handle in the upright, locked position.
To remove tank, press down on handle and pull forward.
Carry tank to a sink.
Rotate tank cap counterclockwise and lift up to remove cap.
General operation - Filling solution tank
Continued
5
Advertisement
Table of Contents
