List Of Error Display / Indication; Operator Call Errors (By Led Blinking In Orange) - Canon i900D Service Manual

2. LIST OF ERROR DISPLAY / INDICATION

Errors are indicated by the LED, and warnings are displayed on the monitor of the computer connected to the
printer.
(1) Errors are indicated by the number of times the LED blinks.
(2) Errors are indicated in the LCD viewer on the operation panel.
(3) Warnings are displayed in the Status Monitor of the printer driver.

2.1 Operator Call Errors (by LED Blinking in Orange)

LED
blinking
in orange
2 times No paper. (ASF) [1000]
No CD-R tray. [1001]
No paper in the photo paper tray.
[1004]
3 times Paper jam. [1300]
4 times No ink.
[1601/1602/1611/1612/1613/1634/
1635]
5 times The print head is not installed
[1401], or it is not properly
installed (EEPROM data of the
print head is faulty) [1403/1405].
*1
6 times No CD-R tray feeder (during
CD-R printing). [1850/1855]
Presence of the CD-R tray feeder
(during paper printing).
[1851/1856]
*1
7 times No CD-R or DVD-R. [1002]
8 times Warning: The waste ink absorber
becomes almost full (approx. 95%
of the maximum capacity). [1700]
9 times The connected digital camera or
digital video camera does not
support Camera Direct Printing.
[2001]
11 times Automatic print head alignment
failure. [2500]
1
* : Only for the model supporting CD-R printing (i905D only)
Error
Set the paper in the ASF, and press the
Resume button.
*1
Set the CD-R tray, and press the Resume
button.
Set the paper in the photo paper tray, and
press the Resume button.
Remove the jammed paper, and press the
Resume button.
Replace the empty ink tank(s), or press the
Resume button.
Install the print head properly, and close the
front cover.
Or, with the print head installed, turn the
printer off and on.
Set the CD-R tray and tray feeder properly,
and press the Resume button.
Remove the CD-R tray feeder, and press the
Resume button.
After setting a CD-R or DVD-R in the tray,
set the tray in the tray feeder, and press the
Resume button.
Pressing the Resume button will exit the
error, and enable printing.
In repair servicing, replace the bottom case
unit (QM2-0663), or 5-item set of the ink
absorbers
(QC1-2232/2233/2234/2235/2236).
After removing the cable between the camera
and the printer, press the Resume button, and
re-connect the cable.
Press the Resume button, and after
confirming the following, perform print head
alignment again:
- Set an appropriate type and size of paper
(plain paper, A4 or letter).
- Check that the nozzle check pattern is
properly printed (all ink ejected, no faint
printing)
- Check that the paper output slot is not
exposed to light.
Solution
1 - 4
Remarks
Pressing the Resume
button will exit the
error without ink tank
replacement, however,
ink may run out during
printing.
The service call error,
indicating the waste
ink absorber is full, is
likely to occur soon.
When connected to a
Direct Print supported
camera, the green LED
blinks 2 times.