Specifications; Assembly - Central Machinery 61712 Owner's Manual

Specifications

Type
Fuel
Capacity
Coolant Tank Capacity
Blade Speed

assembly

Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
tO pRevent SeRiOuS injuRY:
Operate only with proper spark arrestor installed. Operation of this equipment may create sparks that can
start fires around dry vegetation. A spark arrestor may be required.
The operator should contact local fire agencies for laws or
regulations relating to fire prevention requirements.
tO pRevent SeRiOuS injuRY: the Saw mill is dangerous when assembled incorrectly.
If you do not feel completely comfortable assembling it, then have a qualified technician assemble it.
note: For additional information regarding
the parts listed, refer to Assembly Diagram
near the end of this manual.
1. Secure Wheels (1) onto Right Wheel Frame (7a)
with two Hex Bolts M20x100 (6) and Hex Nuts
M20 (2). Attach Right Wheel Frame, Round
Post (20) and the Round Clamp (10) with two
Hex Bolts M12x80 (8) and Hex Nuts M12 (9).
note: Do not tighten Bolts (8) and Nuts (9).
20
8, 9
6, 2
1
Figure a: Right Wheel Frame
2. Secure Wheels (1) onto Left Wheel Frame (3a)
with two Hex Bolts M20x100 (6) and Hex
Nuts M20 (2). Then attach Left Wheel Frame,
Square Post (48) and Square Clamp (4)
Page 6
87+ octane unleaded
gasoline
1 Gallon
4.2 Quarts
3,279 FPM
10
7a
For technical questions, please call 1-800-520-0882.
Log Diameter
Board Width
Cutting Thickness
Cutting Length
note: Engine specifications are found in the
engine manual supplied with this equipment.
with two Hex Bolts (58) and Hex Nuts (5).
note: Do not tighten Bolts (58) and Nuts (5).
3a
Figure B: left Wheel Frame
3. Slide the Round Post (20) into the Blade Guard (50),
as shown below. Adjust the bolts until Blade Guard
20" Maximum
20" Maximum
4-1/2" Maximum
9'-2" Maximum (110")
48
58, 5
4
6, 2
1
ITEM 61712