Mechanical Adjustments - Sony HCD-M100 Service Manual

• TAPE MECHANISM DECK SECTION
Precaution
1. Clean the following parts with a denatured alcohol-moistened
swab:
record/playback heads
erase head
capstan
2. Demagnetize the record/playback head with a head demagne-
tizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to the
parts adjusted.
5. The adjustments should be performed with the rated power sup-
ply voltage unless otherwise noted.
• CD MECHANISM DECK SECTION
To adjust the mechanism section, enter the mechanism section adjustment mode.
For how to enter the mechanism section adjustment mode, refer to each adjustment section.
DISC SENSOR ALIGNMENT
1. Make sure that there is no disc in the unit.
2. Connect an oscilloscope to IC401rs, IC4014 of the MAIN board.
IC401rs D.SENS (CH1)
IC4014 HHOUT (CH2)
GND
3. Press the button to turn ON the power.
@/1
4. Press the button, ENTER button and CLOCK/TIMER SET button simultaneously.
x
18
SECTION 4
MECHANICAL ADJUSTMENT
pinch rollers
rubber belts
idlers
oscilloscope
• Torque Measurement
Torque meter
Mode
FWD CQ-102C
FWD
CQ-102C
back tension
REV CQ-102RC
REV
CQ-102RC
back tension
FF/REW CQ-201B
FWD tension CQ-403A
REV tension CQ-403R
Meter reading
3.06 N • m to 6.96 N • m
31 to 71 g • cm
(0.43 – 0.98 oz • inch)
0.19 N • m to 0.58 N • m
2 to 6 g • cm
(0.02 – 0.08 oz • inch)
3.06 N • m to 6.96 N • m
31 to 71 g • cm
(0.43 – 0.98 oz • inch)
0.19 N • m to 0.58 N • m
2 to 6 g • cm
(0.02 – 0.08 oz • inch)
6.96 N • m to 14.02 N • m
71 to 143 g • cm
(0.98 – 1.99 oz • inch)
9.80 N • m
100 g or more
(3.53 oz or more)
9.80 N • m
100 g or more
(3.53 oz or more)