Download  Print this page

Sony SA-VE230 Operating Instructions (SA-VE230 Speaker System) Operating Instructions Manual

Speakers/stands: micro satellite system - speaker.
Hide thumbs

Advertisement

4-226-572-11(1)
Micro Satellite
System

Operating Instructions

Owner's Record
The model and serial numbers are located on the rear of the unit. Record the serial
number in the space provided below. Refer to them whenever you call upon your
Sony dealer regarding this product.
Model No. SA-VE230 Serial No.
SA-VE230
©2000 Sony Corporation

Advertisement

Table of Contents

   Also See for Sony SA-VE230 Operating Instructions (SA-VE230 Speaker System)

   Related Manuals for Sony SA-VE230 Operating Instructions (SA-VE230 Speaker System)

   Summary of Contents for Sony SA-VE230 Operating Instructions (SA-VE230 Speaker System)

  • Page 1: Operating Instructions

    The model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No. SA-VE230 Serial No.
  • Page 2 WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.
  • Page 3: Table Of Contents

    About this model The SA-VE230 is a 5.1 channel speaker system consisting of two front speakers, two rear speakers, one center speaker, and one subwoofer. It supports Sony Digital Cinema Sound, Dolby* Pro Logic, and Dolby Digital (AC-3), and is thus geared towards the enjoyment of movies.
  • Page 4: Hooking Up The System

    Hooking up the system Connect the speaker system to the speaker output terminals of an amplifier. Make sure power to all components (included the subwoofer) is turned off before starting the hook-up. Front (Right) LINE IN WOOFER OUT Rear (Right) Terminal (jack) connections Subwoofer Center...
  • Page 5 Notes • Make sure the plus (+) and the minus (–) terminals on the speakers are matched to the corresponding plus (+) and minus (–) terminals on the amplifier. • Be sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise. •...
  • Page 6: Positioning The Speakers

    Positioning the speakers Location of each speaker Center Front (Left) Rear (Left) Each speaker should face the listening position. Better surround effect will result if all speakers are set at the same distance from the listening position. Place the front speakers at a suitable distance to the left and right of the television.
  • Page 7: Listening To The Sound

    Listening to the sound LEVEL POWER POWER POWER indicator First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. Turn on the amplifier and select the program source. Press POWER on the subwoofer.
  • Page 8: Precautions

    Setting your amplifier to enjoy movies For the Dolby Digital (AC-3) If your amplifier is connected internally or externally with a Dolby Digital (AC-3) processor, you should use the setup menus for the amplifier to specify the parameters of your speaker system. See the table below for the proper settings.
  • Page 9: Troubleshooting

    Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer. There is no sound from the speaker system. •Make sure all the connections have been correctly made.
  • Page 10: Specifications

    Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 6 ohm loads both channels driven, from 20 - 150 Hz; rated 50 watts per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated output. SS-V230 Front and rear speakers Speaker system Speaker units...
  • Page 12 Sony Corporation Printed in China...

Comments to this Manuals

Symbols: 0
Latest comments: