Installation Of An Add-On Card; The Pre-Installed Fans / Using The Fan Control - Sharkoon Tauron Manual

11. Installation of an add-on card

1. Remove the anchor screw of the slot bezel and take it from the case.
2. Insert the add-on card into the respective slot of the mainboard and attach it to the case using the
anchor screw (fig. 21).
Fig. 21
3. Close the case.

12. the pre-installed fans / using the fan control

The pre-installed fans provide a 3-pin as well as a 4-pin power connector:
B
a
The 3-pin power connector lets you connect the respective fan to a matching power connector of the main-
board (in this case, the fan will be controlled by the mainboard) or a connector of the case's fan control; in
this case the fan speed can be adjusted by using the sliders of the fan controller.
B
A – 3-pin power connector
B – 4-pin power connector
Tauron

21