Draytek Vigor 3200 Series User Manual page 249

Item
Dial-In PPP Encryption
(MPPE Optional MPPE
Mutual Authentication
(PAP)
Assigned IP Start
LDAP Server Profiles
for PPP Authentication
After finishing all the settings here, please click OK to save the configuration.
Description
fall back to use the PAP protocol for authentication.
Optional MPPE - This option represents that the MPPE
encryption method will be optionally employed in the router
for the remote dial-in user. If the remote dial-in user does not
support the MPPE encryption algorithm, the router will
transmit "no MPPE encrypted packets". Otherwise, the MPPE
encryption scheme will be used to encrypt the data.
Require MPPE (40/128bits) - Selecting this option will force
the router to encrypt packets by using the MPPE encryption
algorithm. In addition, the remote dial-in user will use 40-bit to
perform encryption prior to using 128-bit for encryption. In
other words, if 128-bit MPPE encryption method is not
available, then 40-bit encryption scheme will be applied to
encrypt the data.
Maximum MPPE - This option indicates that the router will
use the MPPE encryption scheme with maximum bits (128-bit)
to encrypt the data.
The Mutual Authentication function is mainly used to
communicate with other routers or clients who need
bi-directional authentication in order to provide stronger
security, for example, Cisco routers. So you should enable this
function when your peer router requires mutual authentication.
You should further specify the User Name and Password of
the mutual authentication peer.
Enter a start IP address for the dial-in PPP connection. You
should choose an IP address from the local private network.
For example, if the local private network is
192.168.1.0/255.255.255.0, you could choose 192.168.1.200 as
the Start IP Address.
You can configure up to four start IP addresses for LAN1 ~
LAN4.
Configured LDAP profiles will be listed under such item.
Simply check the one you want to enable the PPP
authentication by LDAP server profiles.
However, if there is no profile listed, simply click the link of
PPTP LDAP Profile to create/add some new LDAP profiles
you want.
For the detailed information of LDAP application, refer to
section 3.1 and 3.2.
239 Vigor3200 Series User's Guide