Toshiba teli BU030 Instruction Manual page 67

● Registers
Register
UserSetSelector
UserSetLoad
UserSetSave
UserSetDefault
● Setting
- Select a channel of a user setting
Set the following value to "UserSetSelector" register. The setting value is Enumeration type.
Select the channel of user setting for "UserSetLoad" and "UserSetSave".
setting value
Default
UserSet1 (*)~15
- Load/Save a user setting
When execute "UserSetLoad", the camera loads user setting from the channel selected in
"UserSetSelector" register and applies them.
When execute "UserSetSave", the camera saves user setting to the channel selected in
"UserSetSelector" register.
- Load a user setting at the time of start-up
Set the following value to "UserSetDefault" register. The setting value is Enumeration type.
The camera loads user setting from the channel selected in "UserSetDefault" register and applies them at
the time of next start-up.
● Note
"UserSetDefault" register value is stored to non-volatile memory when "UserSetSave" is executed.
Thus, "UserSetSelector" shall be set other than "Default" in advance.
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
Visibility Access
Beginner R/W Selects a channel of user setting.
Beginner W Executes load a user setting.
Beginner W Executes to save a user setting.
Beginner R/W Selects a channel of user setting when camera powers up.
Initial factory setting data.
Select memory channel 1 to 15 for user setting.
setting value
Default (*) Memory channel to read initial factory setting data.
UserSet1~15 Memory channel 1 to 15 for user setting.
Description
Description
66 / 76
Description
Save Load
○
-
○ ○
* initial factory setting
* initial factory setting
www.toshiba-teli.co.jp
D4213050G