Kenmore 415.16107110 Use & Care Manual page 16

Tank Heat Shield
7
□
Use four 5/32-32x3/8" machine screws to attach tank heat shield to back brace on one side. Attach other side under
lip of upper front panel as shown.
Grill Head
4 8
□ This step requires two people to lift and position grill head onto card.
□ Cut tie wraps from regulator hose and remove styrofoam. Carefully lower the grill head onto cart,
making sure the regulator hose and sideburner ignition wire are hanging outside cart . Rest the back
and front of grill head on tabs
□ Open top lid, and use four 1/4-20x1/2" machine screws to attach grill head from inner firebox to
cart side braces as shown (B).
□ Use two 1/4-20x1/2" machine screws to attach grill head to the
two rear legs as shown (C).
B
1/4-20x1/2"
Machine Screws
Qty. 6
16 · 464430111
Tank Heat Shield
protruding from front and rear legs as shown (A).
A
C
5/32-32x3/8"
Machine Screws
Qty. 4
Grill Head