Related Manuals for Kenmore 415.1613911
Summary of Contents for Kenmore 415.1613911
- Page 1 Use & Care Guide Model: 415.16139110 Kenmore Elite ® Liquid Propane Gas Grill P/N G523-001-010801 Sears Brands Management Corporation Hoffman Estates, IL 60179 U.S.A. www.kenmore.com www.sears.com Model 464224211 • Nov-03-10...
- Page 2 DANGER WARNING CALIFORNIA PROPOSITION 65 If you smell gas: 1. Combustion by-products produced when using this 1. Shut off gas to the appliance. product contain chemicals known to the State of 2. Extinguish any open flame. California to cause cancer, birth defects, and other reproductive harm.
-
Page 3: Table Of Contents
Table of Contents WARRANTY For Your Safety..............2 KENMORE ELITE FULL WARRANTY Grill Information Center ..........2 If this grill fails due to a defect in material or workmanship within two years from the date of purchase, call 1-800-4-MY- Product Record Information........2 ®... -
Page 4: For Your Safety
LP Tank USE AND CARE • The LP Tank used with your grill must meet the following requirements: DANGER • Use LP Tanks only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. - Page 5 LP Tank Exchange Connecting Regulator To The LP Tank • Many retailers that sell grills offer you the option of 1. LP tank must be properly secured onto grill. (Refer to replacing your empty LP tank through an exchange service. assembly section.) Use only those reputable exchange companies that inspect, precision fill, test and certify their tanks.
- Page 6 Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately.
- Page 7 Safety Tips WARNING • Before opening LP cylinder valve, check the coupling nut for tightness. • When grill is not in use, turn off all control knobs and LP For Safe Use of Your Grill and to Avoid Serious cylinder valve. Injury: •...
- Page 8 Match-Lighting Main Burner Ignitor Lighting • Do not lean over grill while lighting. • Open grill lid during Lighting. • Open lid. Turn on gas at LP cylinder. • Do not lean over grill while lighting. • Light Burners one at time. 1.
-
Page 9: Spider Alert
Sideburner Ignitor Lighting CAUTION Do not lean over grill while lighting. 1. Open sideburner lid. Turn ON gas at LP cylinder. 2. Turn sideburner knob to the HI position, push and hold ELECTRONIC IGNITOR button. SPIDER ALERT! 3. If sideburner does NOT light within 5 seconds, turn knob OFF, wait 5 minutes, then repeat lighting procedure. - Page 10 Cleaning the Main Burner Assembly General Grill Cleaning • Do not mistake brown or black accumulation of grease Follow these instructions to clean and/or replace parts of burner and smoke for paint. Interiors of gas grills are not assembly or if you have trouble igniting grill. painted at the factory (and should never be painted).
- Page 11 Grill Halogen Light LIGHT OPERATION INSTRUCTIONS 1. Make sure light switch on the control panel is in the “OFF” position. 2. Connect light plug to an extension cord, then plug the extension cord into the outlet on the wall. 3. Turn the light switch to “ON”. Light plug WARNING Extension cord,...
- Page 12 Cleaning the Lens 1. Prior to cleaning, make sure the light switch is in the “OFF” position and the light plug is disconnected from the power supply. 2. Do not clean the glass lens when warm. Allow to cool before cleaning. Sudden change in temperature may cause cracking of the glass lens.
-
Page 13: Parts List
PARTS LIST Key Qty Description Key Qty Description Part # Part # LEFT SIDE SHELF G523-1100-W1 BOTTOM SHELF G523-0025-W1 FASCIA, LEFT SHELF G523-0051-W1 DOOR MAGNET ASSEMBLY G501-0016-W2 RIGHT SIDE SHELF G523-1200-W1 TANK SHELF ASSY G523-4100-W1 FASCIA, RIGHT SHELF G523-0052-W1 LEFT SIDE PANEL G523-0800-W1 TOP LID G523-0100-W1... -
Page 14: Parts Diagram
PARTS DIAGRAM 14 • 464224211... - Page 15 Insert flange on left side shelf into side shelf brackets, shown A. Attach left side shelf rear using two 1/4-20x1/2” screws, 7mm lock washers and 7mm flat washers, shown B. Attach left side shelf front using three 1/4-20x1/2” screws, 7mm lock washers and 7mm flat washers, shown C.
- Page 16 Insert flange on right side shelf into side shelf brackets, shown A. Attach right side shelf top using two 1/4-20x3/4” screws, 7mm flat washers, 7mm lock washers and 1/4” nuts, shown B. Attach right side shelf rear using one 1/4-20x3/4” screw, 7mm lock washer and 7mm flat washer, shown C.
- Page 17 Install heat diffusers by sliding one end of each heat diffuser into slots at front of firebox and resting opposite end on pins at back of firebox. Make sure to install the shorter heat diffuser in A position, and install the two longer heat diffusers in B and C position. Heat diffuser Front of firebox Rear of firebox...
- Page 18 Place sideburner grate into sideburner shelf, aligning grate legs with holes in shelf. On back of grill, slide grease tray into opening in lower back panel. CAUTION Failure to install grease tray will cause hot grease to drip from bottom of grill with risk of fire or property damage.
- Page 19 Unscrew electronic ignition cap on cart right side panel. Insert AA battery into ignitor, negative(-) end first. Replace the cap. AA Battery Electronic Ignition Cap LP TANK IS SOLD SEPARATELY. Fill and leak check the tank before attaching to grill and regulator (see Use &...
- Page 20 Install door organizers Back of left door: Attach bag hook by inserting wire ends in the holes on the door, shown A. Attach condiment tray by sliding it onto tabs on lower door back panel, shown A. Back of right door: Attach condiment trays by sliding them onto tabs on upper and lower door back panel, shown B.
-
Page 21: Assembly
EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Possible Cause Prevention/Solution Gas leaking from • Damaged hose. • Turn off gas at LP cylinder or at source on natural gas systems. cracked/cut/burned If the hose is cracked or cut but not burned, simply replace hose. - Page 22 Troubleshooting (continued) Problem Possible Cause Prevention/Solution Burner(s) will not light ELECTRONIC IGNITION: using ignitor. • No spark, no ignition noise. • See Section I of Electronic Ignition System. (See Electronic Ignition Troubleshooting also) • No spark, some ignition noise. • See Section II of Electronic Ignition System. •...
-
Page 23: Troubleshooting
Troubleshooting - Electronic Ignition Problem (Ignition) Possible Cause Check Procedure Prevention/Solution SECTION I No sparks appear at • Battery not installed • Check battery orientation. • Install battery (make sure that “+” and “–” properly. connectors are oriented correctly, with “+” end up any electrodes when Electronic Ignition and “–”...