1. TECHNICAL SPECIFICATIONS
Power output
(20 Hz – 20 kHz simultaneous drive of both channels)
......................................................... 100W x 2 (8Ω load)
Total frequency distortion
(20Hz – 20kHz simultaneous drive of both channels, 8Ω load)
.............................................................................. 0.01%
Output band width (8Ω load, 0.05%) .................. 5Hz ~50kHz
Frequency response (CD, 1W, 8Ω load) .. 5Hz ~ 120kHz±3dB
Dumping factor (8Ω load, 20Hz – 20kHz) ....................... 100
Input sensitivity/Input impedance
PHONO (MC) .............................................. 270µV/100Ω
PHONO (MM) ................................................. 3mV/47kΩ
BALANCED ............................................... 240mV/20kΩ
CD/LINE .................................................... 240mV/20kΩ
Output voltage/Output impedance
PRE OUT ...................................................... 1.9 V/220Ω
Maximum allowed PHONO input (1kHz)
MC .......................................................................... 12mV
MM ....................................................................... 130mV
RIAA deviation (20Hz ~ 20kHz) ............................ ±0.5dB
S/N (IHF-A, 1W, 8Ω load)
PHONO (MC) ................................... 76dB (0.5mV input)
PHONO (MM) ...................................... 90dB (5mV input)
BALANCED ..................................... 95dB (500mV input)
CD/LINE .......................................... 96dB (500mV input)
Tone control
Bass (50Hz) ............................................................. ±8dB
Treble (20kHz) ......................................................... ±8dB
Power requirement ............................. AC 230V 50Hz [/S, /N]
Power consumption
(EN60065) .............................................................. 380W
(4Ω, 200W x 2 output) ............................................ 880W
Accessories
Remote controller .......................................................... 1
AAA batteries ................................................................ 2
Detachable AC power cable .......................................... 1
Maximum outer dimensions (Amp)
Width ................................................................... 440mm
Height .................................................................. 165mm
Depth ................................................................... 444mm
Weight (Amp) .............................................................. 26.0kg
2. CAUTION
The layout of this amplifier is well concerned for sound quality.
1. When screws and washers are removed, those parts must
be set to the same places.
2. When wires are removed, the wires must be installed in the
same roots, same places.
3. Do not hold the side panel (007D) to move the unit when
the unit is disassembled.
200W x 2 (4Ω load)
AC 220V 50/60Hz [/K]
AC 110V 60Hz [/L]
1