Default Program Settings; Installer Setup - Honeywell Chronotherm IV T8600D Installation Instructions Manual

Table 2. Default Program Settings.
Period Time
Wake 6:00 AM
Leave 8:00 AM
Return 6:00 PM
Sleep 10:00 PM

INSTALLER SETUP

NOTE: For most applications, the thermostat factory
settings will not require changing. Review the
factory settings in Table 2 and if no changes are
necessary, go to the Installer Self-Test section.
The Installer Setup is used to customize the thermostat
to specific systems. Some of the options include
temperature display, system changeover, and outdoor
temperature display. Installer Setup numbers are listed in
Table 3. The table includes all the configuration options
and the factory settings for the T8600.
A combination of key presses is required to use the
Installer Setup feature:
— To enter the Installer Setup, press and hold the
information i key with the increase
decrease keys until the first number is displayed.
All display segments appear for approximately three
seconds before the number is displayed. See Fig. 10
and 11.
— To advance to the next Installer Setup, press the
Time ∆ key.
— To change a setting, use the increase
decrease key.
— To scroll the Installer Setup numbers backward, press
the Time ∇ key.
— To exit the Installer Setup, press Run Program.
T8600D CHRONOTHERM® IV DELUXE PROGRAMMABLE THERMOSTATS
Heat Cool
Setpoint Setpoint
70°F 78°F
(21°C) (25.5°C)
62°F 85°F
(16.5°C) (29.5°C)
70°F 78°F
(21°C) (25.5°C)
62°F 82°F
(16.5°C) (28°C)
and
or
Wait Set Program
Recovery
Hold for
Fan
Filter Em Ht
Setting
Mon Tue Wed Thu Fri Sat Sun
Auto
Wake Leave Return Sleep
Auto
Fig. 10. Display of all LCD segments.
Auto
Auto
Fig. 11. Display of Installer Setup number and
CAUTION
Electric Heat System Configuration Hazard.
Can cause equipment damage.
Configure electrical heat system to 1 in Installer
Setup number 2 to prevent system running
without fan.
IMPORTANT
Only configurable numbers are shown on the
device. Example: If thermostat does not have a
System key, Installer Setup Number 12 will not
be displayed. Review Table 3 factory settings
and mark any desired changes in the Actual
Setting column. When Installer Setup is com-
plete, review the settings to confirm that they
match the system.
5
Set Day/Time Temporary Setting
AM
PM
Aux Ht
Days
Repl Batt Room
Heat
DST
FACTORY SETTING OR OTHER
INSTALLER SETUP
CHOICE DISPLAY (COLUMN 3
NUMBER DISPLAY
OR 5 OF TABLE 3)
(COLUMN 2 OF TABLE 3)
setting.
System
Em Heat
Off
Cool
Auto
Fan
Outdoor
On
Cool
Auto
M14559
M14618
69-1409—1