Powering The Homebase Device - Honeywell Dolphin 7850 User Manual

Powering the HomeBase Device

The terminal requires 9.5 volts DC input for communication and battery charging; the power adapter on
the power cable converts the voltage from the power source to 9.5 volts DC. Only power adapter cables
from Honeywell convert the voltage appropriately.
Power Cable
Power Adapter
1. Plug the power cable into the power adapter.
2. Plug the power cable into the power source.
3. Plug the connector cable into the DC power jack on the back panel. The HomeBase device is now
powered.
When a terminal is properly seated in the terminal well, the HomeBase device powers the terminal,
charges the terminal's main battery pack, and launches ActiveSync communication (see
Communication on page 9-8).
Honeywell recommends that you leave the HomeBase device connected to its power source at all times,
so that it is always ready to use.
Dolphin® 7850 Mobile Computer
User's Guide
Rev C
4/30/2008
Plug this connector into the
DC Power Jack on the back
panel.
ActiveSync
9 - 5