Decoding - Honeywell Dolphin 7850 User Manual

Decoding

The Dolphin terminal supports two types of image decoding: full-area imaging and Advanced Linear
Decoding (ALD).
Full-area Imaging
Full-area imaging means that the Dolphin terminal support omni-directional aiming, which
means that a positive read can be obtained from many positions. For details, see
Directional Scanning Positions
ALD
ALD provides fast reading of linear (1D) and stacked linear bar codes (e.g., PDF417). For the
best read, the aiming pattern should be centered horizontally across the bar code. When ALD
is enabled, the reader does not read matrix or postal codes.
To Decode a Bar Code
1. Tap Start > Demos > Scan Demo.
2. Position the Dolphin terminal over one of the sample bar codes on page 5-5.
A range of 4–10 inches (10–25 cm) from the bar code is recommended.
3. Project the aiming pattern by pressing and holding the Scan trigger. The Scan LED lights red
4. Center the aiming beam over the bar code. The aiming beam should be oriented in line with the bar
code to achieve optimal decoding; see
5. Release the Scan trigger.
6. When the bar code is successfully decoded, the decode LED lights green and the terminal beeps.
Sample Bar Codes
You can use the following bar codes to verify decoding:
Sample 128
Code 128
Dolphin® 7850 Mobile Computer
User's Guide
on page 5-4.
Omni-Directional Scanning
Sample PDF417
PDF417 Test Message
Rev C
4/30/2008
Omni-
on page 5-6.
.
5 - 5