Sharp UX-B700 Service Manual page 8

UX-B700U
FO-B1600U
5
Insert the new print cartridge into the
cartridge holder.
6
Place your index finger on the tab as
shown and close the cartridge holder
cover with your thumb. Make sure the
cover clicks into place.
7
Close the print compartment cover.
8
Close the operation panel, pressing
down firmly on both front corners to
make sure it clicks into place.
9
Press (NEW) if the cartridge you
1
installed is new.
Press (OLD) if the cartridge you
2
installed is old.
If you select the wrong number by mistake,
press and repeat the selection.
STOP
START/
10
MEMORY
Press .
If you selected "OLD" in the previous
step, this completes the installation
procedure. (Note: If you find that print
quality is not satisfactory after
reinstalling the old cartridge, align the
cartridge .)
If you selected "NEW", the display will
show the alternating messages at
right. Continue with the following steps
to align the print cartridge.
11
Press to print an alignment page. (To enter an alignment value
1
without printing an alignment page, press
Display:
CHANGE CARTRIDGE
1=NEW, 2=OLD
Display when "1" is selected:
NEW CART.: OK?
OK: PRESS START
Display when "NEW" is
selected:
ALIGN CARTRIDGE
1=PRINT,2=SET
.)
2
1 – 6
Note: If at any time the display shows the
alternating messages at right, check the printing
paper. If the tray is empty, add paper. If there is
paper in the tray, take it out and then reinsert it.
START/
MEMORY
.
When you are finished, press
ADD PAPER &
PRESS START KEY