Database Services; Reset Unit; Product Information; Mains Frequency - Honeywell VRX180 User Manual

Maintenance

8.7 Database Services

The following table describes the prompts.
Prompt
CLEAR ALL MEMORY
FULL UPGRADE
INCREMENTAL UPGRADE
SOFTWARE UPGRADE

8.8 Reset Unit

Select this item to reboot the unit after making changes to Mains Frequency. This function clears all
RAM buffers (storage and display) and accumulated values of some function blocks (Calculated Value
timers, totalizers, and control loop integral) are reset to initial values.This function does not clear
memory.

8.9 Product Information

Select this item to display the product identification, software version number, PROM part number, and
serial number.

8.10 Mains Frequency

Select either 50 Hz or 60 Hz. Afterward you must select RESET UNIT to activate this change.
248

Table 8-4 Database Services Prompts

Clears the Instrument memory of all programming, tuning data, setups, etc. and
restores the original factory-set default values for all parameters, functions and
analog output calibration. Does not affect analog input calibration.
Upgrades all function blocks of the instrument from a disk file with .LNF
extension. Overwrites all function blocks. Executes Clear All Memory after this
service.
Upgrades the instrument with the desired options from a disk file with .LNI
extension. Does not affect existing function blocks or configuration.
Upgrades product software from disk.
Video Recorder – User Manual
Function