Honeywell HRXD9 User Manual page 35

Configuration
Control
Camera Buttons
(1 to 16)
DISPLAY Button
SEQUENCE
Button
FREEZE Button
SPOT Button
MENU Button
ALARM Button
ZOOM Button
PTZ Button
Up, Down, Left,
Right Arrow
Buttons
PANIC Button
Document 900.0856 Rev 3.00
11/07
Note Some buttons on the infrared remote control may not be
supported, depending on the DVR model.
Table 3-1
Description
Pressing the individual camera buttons will cause the selected camera to
display full screen. Buttons 1 to 9 are also used to enter passwords.
The DISPLAY button has two functions. First, it toggles between different
display formats. The available formats are: 4x4, 3x3, 2x2 and PIP. Second,
pressing and holding the button for 5 seconds or longer will switch the video
output between Video Out (BNC or SVHS Out) and VGA Out.
When in the live mode, pressing the SEQUENCE button displays live channels
sequentially.
Pressing the FREEZE button freezes the current live screen.
Pressing the SPOT button allows you to select which cameras will display on
the four Spot monitors. After selecting the monitor you can opt to have that Spot
monitor display a single camera or all cameras sequentially. The infrared
remote control allows you to go directly to the individual Spot monitor menus.
Pressing the MENU button enters the Setup screen. You will need to enter the
authorized user name and password to access Setup. Pressing the button also
closes the current menu or setup dialog box. In Playback mode, pressing
MENU displays the Search menu. In Search mode clip-copying can be done
instantly by pressing and holding the button for two or more seconds.
The ALARM button has two functions. First, it will reset the DVR's outputs
including the internal buzzer during an alarm. Second, it will display the event
log when you are in the live monitoring mode unless there is an active alarm.
This operation can be user password protected.
Pressing the ZOOM button zooms the current image on the screen. A PIP with
a rectangle temporarily displays showing what area of the screen has been
enlarged. You can use the arrow buttons to move the rectangle to another area.
Pressing (Enter) toggles the zoom size between 2x, 3x and 4x.
Pressing the PTZ button enters the PTZ (Pan/Tilt/Zoom) mode which allows you
to control properly configured cameras.
These buttons are used to navigate through menus and GUI. You can also use
them to change numbers by highlighting a number in the menu and using the
Up and Down arrow buttons to increase or decrease the number's value.
The arrow buttons are also used to control Pan and Tilt when in the PTZ mode.
When in the PIP display format, pressing the Up and Down arrow buttons
moves the position of the small screen counter-clockwise and clockwise, and
pressing the Left and Right buttons moves through screen pages.
Pressing the PANIC button starts panic recording of all camera channels, and
displays on the screen. Pressing the button again will stop panic recording.
Front Panel Buttons and Controls
35