Pentax ASAHI SPOTMATIC 23102 Service Manual page 35

DEFECTS:
2.
CAUSES:
NOTE:
Push down the AM switch
lever and check with a
circuit tester if the battery
contact piece B (01018) is
electrically connected with the
print wiring base (10004-).
e. Even when the AM switch
lever (01069) is pushed down,
the switch A (05016) remains
in contact with the switch B
(05018).
NOTE:
Check in the same way as in
the foregoing 1.d.
Broken or disconnected wire or
Short-circuit inside the ammeter.
NOTE:
Unsolder the soldered point of
the lead wire of the ammeter
on the print wiring base (1004)
to remove the-wire, and check
with a circuit tester if the
ammeter is in good working
order.
23102
SERVICING:
e. Adjust the position of (05016)
with tweezers so that it does
not touch (05018) when the
AM switch lever (01069) is
pushed down. (in a state that
the switch actuator pin(02095)
is moved to right as shown
the
in Figure 1. d.
2. Replace the ammeter.
NOTE:
1) No interchangeability
between the ammeter for
Product No. 231 and that
for Product No. 23102.
2) If the ammeter is in good
order when tested with a
circuit tester, it must
indicate approx. 3kΩ.
Page 34