Pentax ASAHI SPOTMATIC 23102 Service Manual page 17

Two types of the high speed cam, (05219) and (05319), are available for critical adjustment of the
shutter speed. Refer to Chapter 5, b. for use of these two cams.
Apply "L-1" lubricant between (06008) and (06009); and between (05002), (05003) and (06002).
(7) Assembly and Adjustment of Slow Speed Governor.
Match the groove of the fan-shaped gear (07009) of the slow speed governor (0-07001) with the
governor actuator stud (07011), and affix (0-07001) to the body proper (01001) with two screws (FM
1.4 x 2.0). Apply a small quantity of "L-4" lube between (06011) and (07009). Cock the shutter at 1/15
or 1/30 sec.
Push the pallet switch lever (07004) in front of the slow speed governor to the right as viewed from the
body front. When (G 04) is hit with the pallet release lever bottom (06007), it moves to the right, and
the pallet (07003) is separated from the star wheel (07008). At this point, turn (06006) and (06010)
clockwise, and the tip of (06006) hits the protruded part of (05057). Pressing down the tip of (06006)
onto (05057), fasten it with two set screws (Set 1. 1.4 x 2.5).
Release the shutter at a speed slower than 1/30 sec. When the fan-shaped gear returns, (07003) must
separate itself completely from (07008).
23102 Page 16