Pentax ASAHI SPOTMATIC 23102 Service Manual page 16

(6) Assembly of Shutter Rest Plate
Cock the shutter. Assemble the governor actuator rod spring (06015) and the governor actuator rod
(06008), and insert them to the hole of the bottom shaft rest (05003).
Assemble the pallet release rod (06009), the pallet release lever collar (06010) and the pallet release
lever top B (06006), and insert them into the hole of the bottom shaft rest (05005) as in the case of
(06008). Leave the screw (Set T 1.4 x 2.5) of (06010) loosened.
Apply a small quantity of "L-1 " lubricant in the hole of the pallet release cam (05057) and on the high
speed cam shaft (05047). Fix the long hole of the high speed cam (05019) onto the selector pin
(05078). Without moving the high speed cam shaft (05047), match the hole of the pallet release cam
(05057) of (05002) with (05047), and then place (05002) on the shutter rest column (03033) and
(01001). At the same time, insert the upper end of the governor actuator rod (06008) into the hole of
the bottom slow speed lever (06002), and then put the upper end of the pallet release rod (06009) into
the hole of (05002).
Fasten (05002) to the body proper (01001) with two screws (SM 1.7 x 3.0), and fix (05002) to the
shutter rest column (03033) with the shutter rest retainer screw (05130).
Move the high speed cam (05019) up and down with tweezers. Adjust the tolerance for this up-and-
down movement between 0.2 mm and 0.3 mm by placing washers (W 6) onto the high speed cam shaft
(05047).
23102 Page 15