Disassembly Of The Set - Sharp VL-A110U Service Manual

VL-E990E

4. DISASSEMBLY OF THE SET

4-1. REMOVAL OF THE CAMERA SECTION
Note:
Before removing the cabinet, turn off the power supply, and ascertain that the battery has been removed.
(b)
(d)
1. Remove one screw ((d)XiPSF20P04000), one screw ((b)LX-
HZ0018TAFF), two screws ((a)LX-HZ0018TAFN), and pull
out the camera front cabinet (1).
(b)
(d)
2. Remove one screw ((b)LX-HZ0018TAFF), one screw
((d)XiPSF20P04000) and two screws ((a)LX-HZ0018TAFN)
and pull out the camera rear cabinet (2) backwards.
Remove the FPC in the camera rear cabinet.
3. Firstly, remove the CCD connector from the Camera PWB, then
remove one screw ((c)LX-HZ0045TAFN), the reverse side in this
figure (Not remove the lens holder in this section).
Lens holder
4. Pulling the lens holder, and pull out the lens upwards. Then,
remove the lens connector.
Pull out
(1)
Camera front cabinet
(2)
Camera rear cabinet
(c)
CCD
connector
Pull out
Lens connector
Connector
(a)
(a)
5. Remove the connector of the 6-cell detection switch, and
remove two screws ((b)LX-HZ0018TAFF) fixing the battery
catcher.
Pull out
Tilt frame C
(a)
Connector
6. Remove two screws ((b)LX-HZ0018TAFF) and pull out the
(a)
camera side cover from the tilt frame C.
7. Remove the battery catcher from the camera side cover.
8.
Remove one connector of the camera PWB, and remove two
screws ((c)LX-HZ0045TAFN) fixing the PWB.
9. After removing the camera PWB from the tilt frame, remove
the connector on the rear of the PWB.
7
(b)
Pull out
(b)
(b)
1
2
(c)
Connector
VL-A110U/UC
VL-AH130U
Connector