Sharp VL-A110U Service Manual page 9

VL-E990E
<3. Removal of the VCR lid>
Microphone connector
Area B
(1) Disconnect the microphone connector.
<Detail of area B>
Microphone connector
(2) Remove the connector cable from the hole of the microphone
wire spacer.
<Detail of area B>
Frame V
(3) Remove the microphone wire spacer from the Frame V.
VCR Lid
(4) Pull out the microphone wire cable with care to prevent it from
interfering with the mechanical parts, and remove the VCR
lid.
Microphone connector
Microphone wire
spacer
Microphone connector
Microphone wire spacer
Caution for installation of the VCR lid
When installing the VCR lid, move the VCR lid in the arrow
direction, keeping the VCR lid parallel to the main body as
shown above.
<4. Removal of the AV unit and AV unit cover>
(b)
(b)
(1) Peel the wire fixing tape.
(2) Remove the AV unit wire.
(3) Remove the AV unit FPC.
(4) Remove two screws ((b)LX-HZ0018TAFF) fixing the AV unit
and LCD holder.
<5. Disassembly of the LCD holder>
(d)
(d)
(1) Remove three screws ((d)XiPSF20P04000) pull out the
tripod angle.
Pull out (b)
(b)
(2) Remove three screws ((b)LX-HZ0018TAFF) on the tilt frame
V.
Move the tilt frame V by a looseness of the tilt FPC.
9
VL-A110U/UC
VL-AH130U
VCR lid
AV unit FPC
Wire fixing tape
AV unit wire
Tripod angle
(d)
(b)