Location And Function Of Controls - LG GCE-8240B Owner's Manual

DirectCD TM v2.5b(s)
Front Panel
Rear Panel

Location and Function of Controls

1. Headphone jack
2. Volume control
3. Emergency Eject Hole
4. Stop/Eject button
5. Disc tray
1. Digital Audio Output Connector
2. Analog Audio Output Connector
3. Jumper Connector
This jumper determines whether the drive is configured as a master or slave.
Changing the master-slave configuration takes effect after power-on reset.
4. IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) Interface using a 40-pin
flat IDE cable.
NOTE : Do not connect or disconnect the cable when the power is on, as this
could cause a short circuit and damage the system. Always turn the power
OFF when connecting or disconnecting the cable.
5. Power Connector
5
1 2 3
6. Drive activity indicators
Two colored LEDs are used to indicate
the operation of CD-R/RW Drive.
(1) Read
The orange color is displayed when the
spindle motor begins the Spin up oper-
ation: accessing data, reading data,
playing Audio, and up loading tray.
(2) Write
The green color is flashed during disc
writing sessions.
1 2 3 4
6
5
4
5