Checking Status In Wireless Multiple Flash-Unit Photography - Nikon Speedlight SB-700 User Manual

Checking Status in Wireless Multiple Flash-unit Photography

Master
k ash unit
Flash-ready
indicator
Blinks for
approx.
3 sec.
D
Goes out
and lights
up when
ready to Ö re
D–28
Remote k ash unit
Flash-ready Sound
indicator monitor
Quickly Three long
blinks for beeps for
approx. approx.
3 sec. 3 sec.
High and
low tone
Quickly beeps
blinks for alternate
approx. for
6 sec. approx.
6 sec.
Speedlight status
InsufÖ cient × ash output for
correct exposure *1
Underexposure due to insufÖ cient
× ash output may have occurred.
To compensate, use a wider
aperture or higher ISO sensitivity,
or move the × ash unit closer to
the subject and reshoot.
• Auto aperture × ash mode or
non-TTL auto × ash mode is
set on the master × ash unit.
Change the × ash mode to an
operable × ash mode.
• The remote × ash unit light
sensor has failed to receive the
command light from the master
× ash unit. This is because the
light sensor cannot detect when
to stop Ö ring in sync with the
master × ash unit, either due to a
re× ection from the remote × ash
unit itself or light from another
remote × ash unit that may
have entered the light sensor
window. Change the direction
or position of the remote × ash
unit and reshoot.