Advertisement
INSTALLATION
How to fix anchors and screws
CAUTION
y Check the wall materials and the thickness of finishing materials.
y
y You can use the anchors and bolts provided with the Laser Display set for walls
y
made from concrete, lightweight concrete, soft fieldstone, hard fieldstone, brick
or cellular blocks.
y When installing it on a wall not specified in this manual, make sure each fixing
y
point withstands an uplifting load of 70 kgf (686 N) and a shearing load of 100
kgf (980 N) or more.
(Attach a plate such as plywood to strengthen the wall before installation.)
a. At each anchor position, use a 8 mm drill bit to make a hole with a depth of
80 mm - 100 mm.
b. Clean the holes.
c. Insert the anchors provided into each hole.
(Use a hammer when inserting the anchor.)
d. Fix a part in place by aligning it with the screw hole.
Tighten the screw with a torque 45 kgf/cm - 60 kgf/cm or higher.
a
Drilling hole
c
Inserting anchor
d
Screw for fixing ring and
space steel
Anchor
Fixing ring and space steel
b
Cleaning hole
Screw for fixing ring and space steel
5
INSTALLATION
Advertisement
