Installing the
Optra W810
9
Lexmark ImageQuick SIMM Setup Guide
SIMM in an
printer
Accessing the
system board
If your Optra W810 has an optional finisher or
mailbox attached, you must remove the option to
access the printer system board. Refer to your
printer documentation for the appropriate steps.
1
Unplug the printer power cord and disconnect
all cables from the back of the printer.
2
Lift off the system board access cover and lay it
aside.
3
Loosen the two screws on the shield. Do not
remove the screws.
4
Remove the shield and lay it aside.