Before You Begin; Printer Requirements; Print Server Requirements - Lexmark ImageQuick SIMM Setup Manual

Before you begin

requirements
Print server
requirements
Note:
If multiple print servers
are installed in your printer,
SIMM functionality is only sup-
ported for one of them.
1
Lexmark ImageQuick SIMM Setup Guide
Printer
The Lexmark
use with Lexmark Optra
W810, and Lexmark C720 laser printers with a
minimum of 8MB memory. Additional memory or
a hard disk may be required for large or complex
jobs.
You need a number 2 Phillips screwdriver to install
the SIMM.
Your Optra T, Optra C710, Optra W810, or
Lexmark C720 printer must either be network-
ready, or be equipped with one of the following
Lexmark MarkNet
• MarkNet N2000t, N2001e, or N2002e
Requires firmware version 3.12.19 or later.
• MarkNet N2501e or N2401e with OptraImage™
Requires firmware version 5.12.19 or later.
To determine your print server firmware version,
print a MarkNet network setup page. For more
information about upgrading firmware, launch the
Drivers, MarkVision™ and Utilities CD, click View
Documentation, and look for the MarkNet link.
The network print server must have TCP/IP
configured and enabled. Refer to your printer
setup manual or your print server manual for
TCP/IP configuration.
™ ™
ImageQuick SIMM is designed for
™
T, Optra C710, Optra
N2000 Series print servers:
™