1. CABINET
A. Release 3 screws (A).
B. Lift up the Cabinet in the direction of arrow (1).
(See Fig.1)
CABINET
(A)
(1)
2. MAIN CIRCUIT BOARD
A. Insert and press a rod in the Emergency Eject Hole and
then the CD Tray will open in the direction of arrow (2).
B. Release 3 screws (B).
C. Remove the Main Circuit Board.
MAIN CIRCUIT BOARD
(2)
EMERGENCY EJECT HOLE
DISASSEMBLY
(A)
(A)
2 HOOKS
Fig.1
(B)
(B)
(B)
Fig.2
3. FRONT PANEL
A. Remove the Front Panel.(The Front Panel is a snap on
type.)
B. At this time, be careful not to damage the 3 hooks (a) of
the it. (See fig.3)
C. Release 3 screws (C) and remove the Cover Bottom (3).
HOOKS (a)
(2)
FRONT PANEL
(C)
4. BASE PICK-UP
A. Remove the FPC Cable. At this time, the FPC connector
must be pulled in the direction of Front carefully.
B. Remove the Base Pick-up (4).
FPC CONNECTOR
BASE PICK-UP
(3)
(C)
COVER BOTTOM
(C)
Fig.3
(4)
Fig.4
7