Download Print this page

NewAir AF-321 Instructions Manual page 6

Advertisement

CLEANING
 
 
Your unit is designed to remove dirt and other atmospheric impurities by drawing in air
 
through the air filter. On no account should be blocked in any way as this will impair the
 
efficiency of the machine. Pushing the unit up against a wall or operating in very close
proximity to long window drapes will impair the air flow and efficiency.
REAR AIR FILTER
This is easily accessible by removing the rear screen and the filter.
In a smoky or dusty environment, this filter becomes grey in colour after one or two
months.
Disconnect machine from mains supply. Gently wash the filter in mild soapy water, dry
and replace. Be sure to ref it the rear screen securely.
No special tools are required for this.
 
 
 
WATER TANK
 
If the unit is in regular service, it is not necessary to clean the water tank regularly. However,
in hard water areas, deposits will build up and it is recommended that cleaning with mild
soapy water once every six months should be sufficient
1.
Disconnect the appliance from mains supply.
2.
Remove complete rear panel by carefully removing the service screws.
Do not use to pull the rear frame out as the mains lead is still connected internally via a
quick fit connector.
3.
When the connector can be seen and reached, disconnect and remove panel
completely.
4.
Remove any deposits or dirt from the tank with a mild soapy detergent and cloth.
5.
Flush with clean water and drain via the drain plug.
6.
Reverse procedure and make sure rear panel is correctly located before replacing and
tightening service screws.
INTERNAL HUMIDITY SCREEN
Use exactly same procedure as for cleaning the water tank.
1.
With the rear panel separated, carefully remove the humidity screen from its rollers.
2.
Soak the screen in warm mild soapy water until clean.
3.
Replace on rollers.
4.
Reverse the removal proceeds.
5.
It is recommended to proceed every 6-12 months.
OUTSIDE CABINET
Use warm mild soapy water and cloth, do not use abrasive products.
 
IMPORTANT
The control panel must not be in contact with water or any other liquids.
5‐ 

Advertisement

loading