Stairmaster SC916 Assembly Manual page 9

Step 6: Removing Console
Tools
• Phillips screwdriver
6-1 Remove the 4 Phillips screws attaching the SC916
Console to the upper mast weldment previously
placed to the side in Step 3 (see Figures 9 and 10 ).
6-2 Remove CHR and J6 Polar HR cables from the
back of the console connected to the PC board (see
Figure 11).
NOTE: After removing the 2 cables from the PC board,
secure the cables to the console plate to keep the
cables from falling into the mast.
6-3 Set the console and the 4 screws to the side.
Assembly
9
Assembly Manual
Figure 9
Figure 10
J6 Polar HR
20 Pin Connector
Contact Heart Rate (CHR)
Figure 11