Chapter 2
Installation
This Chapter covers the physical installation of the Wireless Access Point.
Requirements
Requirements:
TCP/IP network
Ethernet cable with RJ-45 connectors
Installed Wireless network adapter for each PC that will be wirelessly connected to the
network
Procedure
1.
Select a suitable location for the installation of your Wireless Access Point. To maximize
reliability and performance, follow these guidelines:
Use an elevated location, such as wall mounted or on the top of a cubicle.
Place the Wireless Access Point near the center of your wireless coverage area.
If possible, ensure there are no thick walls or metal shielding between the Wireless
Access Point and Wireless stations.
2.
Use a standard LAN cable to connect the "LAN" port on the Wireless Access Point to a
10/100BaseT hub/switch on your LAN.
3.
Connect the supplied power adapter to the Wireless Access Point and a convenient power
outlet, and power up.
4.
Check the LEDs:
The Power LED should be ON.
The LAN and Wireless LEDs should be ON.
For more information, refer to Front Panel LEDs in Chapter 1.
Figure 5: Installation Diagram
2
6