Appendix H. Microsd Card; Microsdhc Compatibility; Microsd Card Insertion - Datalogic Magellan 3300HSi Product Reference Manual

microSDHC Compatibility

At the time of this writing, the microSD card interface for this product supports SD-Memory Card Specifications/
Part 1. Physical Layer Specification; Version 1.01, but the processor MCI can communicate with SDHC Cards. For
example, the scanner can perform the functions specified in this appendix for the SDA 2.0 specification. Both
FAT16 and FAT32 formats are supported.
Filenames are limited to the 8.3 file naming format (i.e., FILENAME.EXT), and MUST be capitalized.
Coin Slot
The microSD card slot is spring loaded. Keep your fin-
ger lightly in place atop the card until you are sure it is
fully seated in place. See the illustration on the follow-
ing page.
CAUTION
Use your finger or thumbnail to push in on the top edge
of the card to be slightly below flush with the scanner
enclosure when inserting or removing the card. This
will engage/disengage the spring mechanism.
Never insert tools or other foreign objects into the
microSD card slot.
6. If installed properly, you should immediately hear an audible signal upon insertion or removal of a microSD
card. Various operations will also be indicated by the scanner's good read LED.
Product Reference Guide

microSD Card Insertion

Top Cover
1. Read all of these instructions before starting.
2. If you have not already done so, remove the scanner from its
installed position to allow access to the microSD card slot.
3. Use a coin or similar blunt object to lever the top cover from the
Lift Handles
scanner, then grasp the lift handles and carefully lift the unit
from the counter.
4. Ensure there are no other cables attached to the scanner, then
apply power and wait for the reset beep.
5. Lift and rotate the rubber cover to access the card slot, then care-
fully insert the microSD card into the slot until it "clicks" into
place.
Appendix H
microSD Card
Rubber
Cover
microSD Card Slot
181