Arctic Cat 450 2010 Service Manual page 35

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Place a spring retainer over the valve springs; then
using the valve spring compressor, compress the
valve springs and install the valve keepers.
PISTON ASSEMBLY
NOTE: Whenever a piston, rings, or pin are out of
tolerance, they must be replaced.
Cleaning/Inspecting Piston
1. Using a non-metallic carbon removal tool, remove
any carbon buildup from the top of the piston.
2. Inspect the piston for cracks in the piston pin,
boss, top, and skirt areas.
3. Inspect the piston for seizure marks or scuffing. If
piston is scored or galled, replace it with a new
one.
4. Inspect the perimeter of each piston for signs of
"blowby" indicated
"Blowby" is caused by worn piston rings, exces-
sive carbon in ring grooves, or an out-of-round
cylinder.
Removing Piston Rings
1. Starting with the top ring, slide one end of the ring
out of the ring-groove.
www.mymowerparts.com
3-14
Back
ATV-1011A
CC132D
by dark discoloration.
Manual
Table of Contents
2. Remove each ring by working it toward the top of
the piston while rotating it out of the groove.
NOTE: When installing new rings, install as a
complete set only.
Cleaning/Inspecting Piston Ring
Grooves
1. Take an old piston ring and snap it into two pieces;
then grind the end of the old ring to a 45° angle
and to a sharp edge.
2. Using the sharpened ring as a tool, clean carbon
from the ring grooves. Be sure to position the ring
with its tapered side up.
CAUTION
Improper cleaning of the ring grooves by the use of
the wrong type of ring groove cleaner will result in
severe damage to the piston.
Measuring Piston-Ring End Gap
(Installed)
1. Place each piston ring in the wear portion of the
cylinder. Use the piston to position each ring
squarely in the cylinder.
2. Using a feeler gauge, measure each piston-ring
end gap. Acceptable ring end gap must be within
specifications.
Section
Table of Contents
CC400D
CC995
Next