Honda QH5000 Operator's Manual page 5

2. Install a 5/s2-inch cotter pin in one end of
the pivot rod, and place a 7/8-inCh flat
washer on the inner side of the cotter pin.
3. Lift the rear of the Quick-Hitch into
position between the hitch pivots, and
secure the hitch with the pivot rod.
4. Place a 7/8-inCh washer on the pivot rod,
and secure the rod with a 5/32 x 215/i6-inch
spring clip.
5. RT5000 and H5013 Tractors:
Tighten the 8mm flange bolts on the hitch
pivots that were installed in step 1, c.
6. Attach the lower ends of the links to the
Quick-Hitch with two '18 x 1 5/8-inCh clevis
pins. Install the clevis pins from the outer
sides of the lift links.
7. Secure the lower clevis pins with 5/32-inch
cotter pins.
8. Attach the upper ends of the lift links to
the Quick-Hitch with the remaining two
5/8 x AS/s-inch clevis pins.
InStall
the clevis
pins from the outer sides of the lift links.
9. Secure the upper clevis pins with 5/32 x
2"/is-inch spring clips.
ATTACHMENT MOUNTING
1. Position the tractor so the Quick-Hitch is
close to the female coupling on the
attachment.
2. Lower the Quick-Hitch to approximately 3/4
of an inch from the ground. Refer to your
tractors owner's manual for hydraulic lift
system operating instructions.
3. With the Quick-Hitch lever in the UNLOCK
position, slide the attachment's female
coupling all the way onto the Quick-Hitch.
4. Move the Quick-Hitch lever to the LOCK
position, and secure the latch with the linch
pin, as shown.
5/32"
COTTER PIN
11/16"
FLAT
WASHER
5. Connect the attachment's PTO drive shaft,
if applicable.
4