Honda HRA216 Owner's Manual page 27

3. Pull the starter grip until resistance is felt. This closes the valves and
helps to protect the combustion chamber from corrosion.
STARTER GRIP
i
4. Coat areas that may rust with a light film of oil. Cover the mower and
store it on a level surface in a dry, dust free area.
Removal from Storage
1. Remove the spark plug; check that it is clean and properly gapped (p.
32). Pull the starter rope several times.
2. Thread the spark plug in as far as possible by hand, then use the plug
wrench to tighten l/8 to l/4 turn further.
3. Check the engine oil level and condition.
4. Fill the fuel tank and start the engine.
NOTE: If the cylinder was coated with oil, the engine will smoke briefly at
start up; this is normal.
25