Changing Temperature Setpoint Until Next Program Period - Honeywell T7351 User Manual

NOTE: The default temperature setting
is the Not Occupied setpoint.
3. Press to display the default setpoint.
NOTE: The only way to change this
setpoint is to change the Not
Occupied setpoint.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9
yourhome.honeywell.com
Changing Temperature
Setpoint Until Next Program
Period
1. Press up
temperature is displayed.
2. The temporary temperature appears for
approximately ten seconds, then the
room temperature is displayed.
® U.S. Registered Trademark
© 2010 Honeywell International Inc.
63-2652—01 K.K. Rev. 05-10
Printed in U.S.A.
or down until the desired