Installation - Tannoy CMS50 User Manual

3.3. Installation

The CMS50 ICT is supplied as a complete product, ready for installation. An optional
C Ring, Tile Bridge and Plaster Ring are available if required. The CMS50 ICT has
been designed for ease of installation.
To install the speaker, connect the speaker as described in the section 3.2. The
speaker has 3 tags (Figure 3f) which hold the speaker in place. Ensure these tags are
flat against the can before installing into the ceiling.
Tags for fastening speaker
Screws for tightening tags
Figure 3f
Slide the speaker through the 210mm hole, as shown in figure 3i, and tighten the
outer screws on the front baffle. Tighten these screws until a secure grip is
established as shown in Figure 3g.
Figure 3i
8