Wireless Sniffer Board - Dell XPS M1330 Service Manual

Wireless Sniffer Board: Dell XPS M1330 Service Manual
Back to Contents Page

Wireless Sniffer Board

Dell™ XPS™ M1330 Service Manual
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching
an unpainted metal surface (such as the back panel) on the computer.
NOTICE:
Handle components and cards by their edges, and avoid touching pins and contacts.
1. Follow the instructions in
2. Remove any installed ExpressCards from the ExpressCard slot.
3. Remove the palm rest (see
4. Remove the express card cage (see
5. Disconnect the wireless sniffer board cable from the system board.
6. Remove the two M2 x 3-mm screws from each side of the sniffer board and remove it from the computer base.
1 wireless sniffer board cable connector
Back to Contents Page
file:///C|/Users/SIIES/Downloads/Dell XPS 1330/sniffer.htm#wp1000550[16/07/2010 06:29:01 p.m.]
Before You Begin.
Palm Rest).
ExpressCard Reader
2 M2 x3-mm screws (2) 3 wireless sniffer board