Honda H4514H Owner's Manual page 82

Uneven mowing;
1. Lawn tractor speed too fast-shift to lower speed.
2. Grass accumulation-
Clean inside deck (see page 77).
inside deck.
3. Dull blade.
WReplace blade or see your authorized
Honda lawn tractor dealer.
4. Tires improperly inflated.-
Check tire inflation (see page 29).
5. Mower not level.
~Check cutter deck mounting.
See your authorized lawn tractor
dealer.
6. Wrong cutter deck height.-
Change to proper height.
7. Chute clogged (if equipped-Empty grass bag and chute.
with optional grass bag).
8. Lawn wet
hallow to dry before cutting.
9. Cutter deck set too low.- Set cutter deck high.
10. Not overlapping cut enough-see page 43.
to compensate for grass
conditions.
11. Throttle setting too
low. -Set to FAST.
Clogged cutter deck discharge chute.
1. Wrong blade.
muse a genuine Honda blade or
equivalent.
2. Deck
too low.
praise deck and adjust deck height
properly.
3. Engine overloaded.- Operate at full throttle. Use lower
speed range. Set cutter deck higher
than desired height for first pass,
then cut to desired height on second
pass.
4. Wet lawn )Mow when lawn is dry.
5. Lawn too tall )Set cutter deck higher than desired
height for first pass, then cut to
desired height on second pass.
6. Low engine rpm
mOpen throttle fully.
7. Grass bags full ,Empty grass bags.
(Optional part).
8. Blades install upside down-
Check blade installation (see page
70).
80