SOMFY Telis 5 Modulis RTS Silver 1810663 Instructions

SOMFY INSTRUCTIONS
TELIS RTS MODULIS

REMOTE CONTROLS

Part #'s
1810663 Telis 5 Modulis RTS Silver
1810664 Telis 5 Modulis RTS Lounge
PROGRAMMING – INITIAL INSTALLATION
Note: During initial programming it is recommended to provide power only to the motor or RTS receiver being programmed.
1. Set the RTS motor or receiver in Programming Mode. (Refer to the installation instruction of the relevant RTS motor or receiver for this procedure.)
2. Select a channel to be memorized
by pressing the Channel Selector
button. The LED lights will illuminate
up each time the Channel Selector
Button is pressed to show what
channel is being operated.
PROGRAMMING - ADDING A NEW REMOTE
1. With your current remote, select the shade
to operate by pressing the Channel Selector
Button. The LED lights will illuminate
each time the Channel Selector Button is
pressed to show what channel is being
operated.
3. Get the new remote and select the
new channel.
PROGRAMMING - SETTING FAVORITE POSITION
1. Select the shade to operate by pressing the
Channel Selector Button. The LED lights will
illuminate each time the Channel Selector
Button is pressed to show what channel is
being operated.
© Copyright SOMFY SYSTEMS, INC. 7/2009
Up
Tilt
Scroll
Wheel
3. Using a paper clip, pen or similar
my
LED Lights
Channel
Selector
2. Using a paper clip, pen or similar device,
my
4. Using a paper clip, pen or similar device,
press and hold the Programming Button
on the back. The window shade will jog.
my
This remote will now operate your shade
or awning.
2. Using the up (
or the scroll wheel, bring the window to
your favorite position, for example halfway
my
down or slats open. Press the center (
button to stop movement at the desired
location.
C - 0002
Down
Stop
my
LED
Channel
Programming
Indicator
Channel
Selector
device, briefly press the Programming
Button (for 1 second) located on
the back of the remote. The RTS
motor or receiver will confirm the
addition of the remote in their
respective manners.
press and hold the Programming Button
on the back of the remote until your
window shade jogs up then down.
) or down (
Pen
Button
BACK
Pen
Programming
Button
BACK
Pen
Programming
Button
BACK
Pen
Programming
Button
BACK
) buttons
UP
DOWN
TILT
my
)
my
SCROLL
WHEEL
PAGE1 REV 1