Remote Control Battery Installation; Remote Control Operating Range; Remote Control Code - Sanyo PLC-WU3800 Owner's Manual

Remote Control Battery Installation

Open the battery
1
compartment lid.
To ensure safe operation, please observe the following precautions :

Remote Control Operating Range

Point the remote control toward the projector when pressing
the buttons. Maximum operating range for the remote
control is about 16.4'(5 m) and 60 degrees in front of the
projector.

Remote Control Code

The 2 different remote control codes (Code 1 - Code 2) are assigned to this projector.
Switching the remote control codes prevents interference from other remote controls when
several projectors or video equipment next to each other are operated at the same time.
Change the remote control code for the projector first before changing that for the remote
control. See "Remote control" in the Setting Menu on page 56.
Press and hold the MENU and IMAGE buttons for more than
five seconds to switch between the Code 1 and Code . The
initial code is set to Code 1.
Install new batteries

into the compartment.
Two AAA size batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
Part Names and Functions
Replace the
3
compartment lid.
16.4'
(5 m)
30°
30°
Remote control
MENU button
IMAGE button
13