Rear Terminal - Sanyo PLC-WU3800 Owner's Manual

Part Names and Functions

Rear Terminal

CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector with
the serial control cable.
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.15,17).
COMPUTER IN  / MONITOR OUT
– Connect computer output to this terminal (p.15).
– This terminal can be used to output the incoming
analog RGB signal and component signals from
COMPUTER IN 1/COMPONENT IN terminal to the
other monitor (p.15).
HDMI
Connect the HDMI signal (including sound signal)
from video equipment or the DVI signal from
computer to this terminal (pp.15, 17).
is registered trademarks of HDMI
*
Licensing, LLC.
LAN Connection Terminal
Connect the LAN cable (refer to the owner's manual
of "Network Set-up and Operation").
S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.16).
10
*
AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.15 -17).
This terminal outputs sound from AUDIO IN terminal
( or ).
Never plug headphones and earphones into AUDIO
OUT jack.
COMPUTER 1 COMPONENT / COMPUTER 
AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to
or to this jack. (pp.15, 17)
AUDIO IN
Connect the audio output signal from video
equipment connected to
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.16).
VIDEO IN
Connect the composite video output signal to
this jack (p.16).
,
or to this jack.