Advertisement
32. Place the CD changer trim on the CD changer,
and install the four self-tapping screws.
CD CHANGER TRIM
SELF-TAPPING
SCREWS
33. Remove 40 to 50 mm of the adhesive backing
from the back of each spacer, and fold them
back. Position the spacers on the CD changer
against the CD changer trim; then carefully
remove the adhesive backings while holding the
spacers in place. Be careful not to tear the
adhesive backings.
SPACER
CD CHANGER
TRIM
SPACERS
34. Wrap one EPT sealer around the connector from
the CD changer.
8 of 10
SELF-TAPPING
SCREWS
CD CHANGER
ADHESIVE
BACKING
CD CHANGER
EPT SEALER
AII 23268 (0110)
35. Remove the vehicle harness clip from the hole in
the inner panel.
CLIP
36. Slide one clip nut onto each of the four holes in
the inner panel.
37. Apply one EPT sealer to the left taillight harness.
LEFT TAILLIGHT
HARNESS
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
CLIP NUT
EPT SEALER
Advertisement
