Tools And Supplies Required; Installation - Honda CD Changer Installation Instructions Manual

TOOLS AND SUPPLIES REQUIRED

#2 Phillips screwdriver
Flat-tip screwdriver
Stubby Phillips screwdriver
10 mm Combination wrench
Ratchet
10 mm Socket
Diagonal cutters
Utility knife
Tape measure
Gloves
Illustration of the CD Changer Installed on the
Vehicle
BUS CORD

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by "do-it-yourselfers."
1. Write down the frequencies for the radio station
preset buttons.
2. Disconnect the negative cable from the battery.
2 of 10
CD CHANGER
(sold separately)
AII 23268 (0110)
3. Remove the two bolts that fasten the glove box,
and remove the glove box.
GLOVE BOX
BOLTS
4. Remove the center lower cover by removing the
two screws, releasing the 11 clips, and
disconnecting the connector.
SELF-TAPPING
SCREW
CENTER
LOWER
COVER
SCREW
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
CLIP
CONNECTOR