Advertisement
45. Secure the BUS cable connector to the vehicle
harness 135 mm away from the vehicle harness
clip with one long wire tie. Attach the BUS cable
to the corner of the body panel with one cushion
tape in the area shown.
BUS CABLE
CUSHION TAPE
Secure to the
corner.
46. Using a utility knife, cut out the marked areas
from the back of the left trunk side board. First
cut out areas A, B, and C, then area D.
A
B
C
10 of 10
CD CHANGER
LONG WIRE TIE
135 mm
BUS CABLE
CONNECTOR
BACK OF
LEFT TRUNK
SIDE BOARD
D
Cut across.
47. Reinstall the left trunk side board on the CD
changer brackets, and install the two clips.
CD CHANGER
BASE BRACKET
48. Reinstall the trunk box, and check that the CD
can be loaded and ejected properly by opening
the lid of the CD changer.
49. Plug the BUS cable connector, the radio
connector, and the antenna lead into the rear of
the radio.
50. Check that all wire harnesses are routed
properly and all connectors are plugged in.
51. Reconnect the negative cable to the battery.
52. Reset the clock and the radio station presets.
53. Reinstall all removed parts.
54. Check the operation of the CD changer as
described in the Owner's Manual supplied.
55. Put the CD Changer Owner's Manual and the
shipping screws (removed in step 26) in the glove
box for your customer.
AII 23268 (0110)
LEFT TRUNK
SIDE BOARD
RADIO
BUS CABLE
CONNECTOR
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
BASE
BRACKET
CLIPS
Advertisement
