Setting The Dp1.2 Display - Dell UP2414Q User Manual

Setting Up the DP1.2 Display
The default out of factory setting in the UP2414Q is DP1.1a.
To enable 3840 x 2160 at 60 Hz, ensure the graphics card of the DP source is
DP1.2 certified with MST feature, capable of supporting resolution up to 3840
x 2160 at 60 Hz, and its driver supports DisplayID v1.3, then change the DP
setting to DP1.2 by performing the below steps:
A) Monitor is able to show content
1. Use OSD button to navigate to Display Settings.
Dell UP2414Q
Brightness/Contrast
Input Source
Color Settings
Display Settings
PBP Settings
Energy Settings
Menu Settings
Other Settings
Personalize
Resolution: 3840x2160, 30Hz
2. Go to DisplayPort 1.2 selection.
3. Select Enable or Disable accordingly.
4. Follow the screen message to confirm selection of DP1.2 or DP1.1a.
Dell UP2414Q
Please ensure your Graphics Card can support DP MST (Daisy chain)/HBR2 (High
Bit Rate) before changing the monitor setting to DP1.2.
Incorrect setting may result in blank screen on monitor.
Dell UP2414Q
DP MST/HBR2 will be disabled for DP1.1a.
Energy Use
Aspect Ratio 16:9
Sharpness 50
Noise Reduction
Dynamic Contrast
Uniformity Compensation O
DisplayPort 1.2
Display Info
Reset Display Settings
Confirm
Exit
Confirm
Exit
Operating the Monitor 45
