Advertisement
Quick Links
Advertisement
Related Manuals for ProForm ZX2
Summary of Contents for ProForm ZX2
- Page 5 M4 x 5mm M4 x 16mm M8 Split Bright Screw Screw (90)–8 M8 Locknut M8 Washer (91)–1 (72)–4 Washer (75)–8 (43)–2 M10 x 95mm Patch M8 x 20mm Screw (76)–4 Patch Screw (74)–4 M6 x 70mm Bolt Set (50)–1 M6 x 60mm Bolt Set (51)–1...
- Page 9 clockwise counter- clockwise...
- Page 21 carbohydrate calories fat calories...
Need help?
Do you have a question about the ZX2 and is the answer not in the manual?
Questions and answers
I have a ZX2 ProForm bike. The panel lighting suddenly went blank. Any suggestions on how to troubleshoot, or is there a schematic diagram available? I have a Volt/Ohm meter if needed. I get an error when adding a photo. Thank you
To troubleshoot the panel lighting issue on a ProForm ZX2 bike, follow these steps:
1. Check Power Supply – Ensure the bike is properly plugged in and receiving power.
2. Inspect Console Settings – If the display is not lighting up, try pressing any button or pedaling to wake it up.
3. Adjust the Reed Switch – If the console is not displaying feedback correctly:
- Slide the Reed Switch slightly toward or away from the Magnet.
- Retighten the M4 x 12.7mm Flange Screws.
- Rotate the Left CrankArm for a moment to check if the display responds correctly.
4. Clean Metal Contacts – If the heart rate or other readings are not displaying properly, clean the metal contacts with a soft cloth (avoid alcohol or abrasives).
5. Reset Console – If the display is unresponsive, try turning the bike off and on.
If the issue persists, consider checking for loose connections or contacting customer support.
This answer is automatically generated
Crank arm came off- how to fix? Not sure if it stripped? Also, wheel seems out of balance and pedaling is not a smooth action as it once was. Thanks.
To fix a crank arm that came off on a ProForm ZX2 and address issues with wheel balance and smooth pedaling:
1. Reattach the Crank Arm:
- Ensure the crank arm is properly aligned with the crank assembly.
- Use appropriate screws (e.g., M4 x 12.7mm Flange Screws) to securely tighten the crank arm back into place.
2. Adjust the Reed Switch (if feedback issues occur):
- Use a flat screwdriver to release the tabs on the left disc cover.
- Remove the left disc cover carefully.
- Slide the Reed Switch slightly toward or away from the magnet.
- Retighten the screws, rotate the crank arm, and test the console feedback.
- Reattach the left pedal, disc cover, and pedal disc once the adjustment is correct.
3. Address Drive Belt Slippage (if pedaling feels uneven):
- Remove the right pedal, seat post, top shield cover, and rear shield to access the drive belt.
- Follow the manual's instructions to adjust the drive belt tension if the pedals slip, even at the highest resistance.
4. Check for Overall Stability:
- Inspect and tighten all parts regularly.
- Replace any worn parts immediately to ensure smooth operation and wheel balance.
Ensure proper clearance around the exercise cycle and avoid overexertion during use.
This answer is automatically generated