Table of Contents
Advertisement
16
Follow these instructions to install add-on cards:
1.
Open the chassis and then remove the slot bracket from the case where you
will be installing the expansion cards.
2.
Install your graphics card in the proper slot by pressing the card firmly into
the slot.
3.
Drive in the screw to secure the slot bracket of the expansion card.
4.
Replace your computer's chassis cover.
Power on the computer, if necessary, set up BIOS utility of expansion card
5.
from BIOS.
6.
Install related driver to complete the installation.
Notes:
The two PCIE x16 slots
1.
With only one PCI Express Graphics card, install it onto PCIE1 slot by default. Having
two PCI Express Graphics cards at hand, set them up onto PCIE1 and PCIE2 slots
simultaneously.
2.
The Scalable D.G.E. supports a four-monitor configuration when
slot are working simultaneously.
3.
Please note that the graphics card driver supports Windows 2000/XP only.
Make sure to connect a 4-pin ATX power cable to the ATX4P1; otherwise, the system
4.
will be unstable.
Installing two graphics cards
(SLI Mode: x8+x8, single PCI-E is x8 mode)
Installing the Motherboard
run in two modes.
PCIE1
slot and
PCIE2
Hide quick links:
Advertisement
Table of Contents
