ECS NF650iSLIT-A Manual page 40

34
CPU L1 & L2 Cache (Enabled)
All processors that can be installed motherboard use CPU internal cache memory to
improve performance. This items enables or disables the actual CPU internal level 1/
2 cache function. Leave this item at default value for better performance.
Hyper-Threading Technology (Enabled)
This item is only available when the chipset supports Hyper-Threading and you are
using a Hyper-Threading CPU.
Quick Power On Self Test (Enabled)
Enable this item to shorten the power on self testing (POST) and have your system
start up faster. You might like to enable this item after you confident that your
system hardware is operating smoothly.
First/Second/Third Boot Device (Removable/Hard Disk/CDROM)
Use these three items to select the priority and order of the devices that your system
searches for an operating system at start-up time.
Boot Other Device (Enabled)
When enabled, the system searches all other possible locations for operating system
if it fails to find one in the devices specified under the First, Second, and Third boot
devices.
Boot Up Floppy Seek (Disabled)
If this item is enabled, it checks the size of the floppy disk drives at start-up time.
You don't need to enable this item unless you have a legacy diskette drive with 360K
capacity.
Boot Up NumLock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
Gate A20 Option (Fast)
This item defines how the system handles legacy software that was written for an
earlier generation of processors. Leave this item at the default value.
Typematic Rate Setting (Disabled)
If this item is enabled, you can use the following two items to set the typematic rate
and typematic delay settings for your keyboard.
♦
Typematic Rate (Chars/Sec): Use this item to define how many characters per
second are generated by a held-down key.
♦
Typematic Delay (Msec): Use this item to define how many milliseconds must
elapse before a held-down key begins generating repeat characters.
Security Option (Setup)
If you have installed password protection, this item defines if the password is
required at system start up, or if it is only required when a user tries to enter the
Setup Utility.
MPS Version Control For OS (1.4)
This item displays MPS version control for OS.
Using BIOS